RA/RM-1D RA/RM-2D RKE 300 822 70 69-02 RKE 400 �� page 3 �� página 9 �� side 15 �� sida 21
WASTE MANAGEMENT EN Appliances bearing this symbol must be deposited at the designated local reception point for the disposal of electrical and electronic equipment. It is not permitted that this product be disposed of by way of the normal household refuse collection system. NO Apparater som er kjennetegnet med dette symbolet, må deponeres på lokale deponier for elektriske eller elektroniske apparater. Dette produktet må ikke kastes sammen med vanlig husholdningsavfall.
OPERATING AND INSTALLATION INSTRUCTIONS FOR REFRIGERATORS RKE 300 AND RKE 400 CONTENTS INSTALLATION _______________________________ 4 ELECTRIC OPERATION _______________________ 6 FILLING THE TANK ___________________________ 4 CHANGING FROM KEROSENE OPERATION TO ELECTRIC OPERATION OR VICE VERSA . . . . . . . . . . .6 LIGHTING THE BURNER _______________________ 4 CHANGING THE HEATING ELEMENT . . . . . . . . . . . . . . .7 MAINTENANCE ______________________________ 5 LIGHTING . . . . . . . . . . . . .
INSTRUCTIONS FOR USE 7. Carefully lift the tank by means of the lever arm and check that the guide pin enters the hole in the bracket on the left side of the burner (FIG. 3). Make sure that the sealing ring on the top of the lamp glass seals against the bottom of the flue tube, it should not be any air gap between the flue tube and the sealing ring. INSTALLATION • The cabinet must be installed on a firm floor and must be in a horizontal position.
MAINTENANCE FIG. 4 CLEANING WICK AND BURNER While the flame is burning, carbon forms on the top of the wick, on the flange of the outer wick tube and on the surface of the flame spreader. For the best refrigeration results and to prolong the life of the wick, this carbon must be cleaned off every two or three days for the first two weeks and at least once a month thereafter, provided a good grade of kerosene is used. When poor grade kerosene is used, the burner should be cleaned at least once a week.
CLEANING THE FLUE SYSTEM FIG. 6 Cleaning of the flue at least once every year is recommended. Poor grade kerosene may cause the burner to smoke, and as soot will then collect in the flue it should be cleaned immediately. To clean the flue: 1. Remove the tank and burner. 2. Lift off the flue cap, complete with wire and flue baffle, and place a sheet of paper underneath the flue tube to catch the soot. 3. Clean the flue with the brush supplied with the refrigerator. 4.
CHANGING THE HEATING ELEMENT FIG. 7 The heater, which is fitted inside the boiler casing (B), FIG. 7, of the refrigerator unit, can be changed as follows: 1. Pull the power cord out of the wall socket. B 2. Remove the cover (C). 3. Remove some insulation wool so that the heater (A) is accessible. C 4. Open the terminal block cover and disconnect the heater leads. 5. Turn and lift the heater out of its pocket. 6. Fit the new heater into the pocket. A 7.
APPENDIX A - BURNER PARTS ALADDIN 23E ALADDIN 32 A B C L D E F G H M I J N Burner Parts (Aladdin 23E) Burner Parts (Aladdin 32) 1. Seal ring A. Seal ring 2. Lamp glass B. Lamp glass 3. Gallery C. Gallery 4. Outer wick tube D. Flame spreader 5. Flame spreader E. Outer wick tube 6. Burner base F. Locking nut 7. Wick turner G. Wick 8. Wick cleaner H. Wick carrier 9. Wick carrier I. Burner base 10. Wick J. Tank sleeve 11. Burner complete (without lamp glass and seal ring). K.
MO-M 0543
