miniBar RH 439LD RH 449LD Type: MB20-60 Free-standing and Built-in versions Operating instructions 207.5396.
Please read these operating instructions carefully before putting the refrigeration unit into operation. If you later sell or dispose of it, please ensure that the new owner receives these operating instructions. Please follow the installation details below carefully. Guarantee is valid for products installed as described only. (See chapter 4.1.) Thank you for choosing our appliance. We are sure it will provide you with trouble-free use.
CONTENTS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. Unpacking View of the appliance Cleaning Positioning the appliance 4.1. Installation instruction 4.1.1. Built-in version 4.1.2. Free-standing version Using the appliance 5.1. Initial operation 5.2. Temperature regulation 5.3. Cooling unit control (CUC) Ice cubes Useful suggestions Defrosting, cleaning and maintenance 8.1. Automatic defrost function 8.2. Interior light 8.3.
1. Unpacking After removal from the cardboard packaging, make sure the appliance is not damaged. If you find damage to the appliance resulting from transport, report it immediately to the transportation firm. 2. View of the appliance Built-in version Free-standing version Figure 1. 1. 2. 3. 4. 5. 6. 7. Door Door lock (if available) Ice tray Lamp Evaporator cover Evaporator sensor (behind evaporator) Evaporator 8. 9. 10. 11. 12. 13.
3. Cleaning Clean the refrigerator thoroughly at intervals, as necessary. Remove the shelves; these, parts, as well as the cabinet interior and the door should be washed with a warm solution of sodium bi-carbonate. Finally wipe over with a cloth rinsed in warm water only, and dry with a clean cloth. Do not wash any plastic parts in water that is more than hand warm, and do not expose them to dry heat. The outside of the cabinet should be wiped down regularly with a clean, damp cloth.
refrigerator by using the remote control. This resets the unit and it will function again. If the countinous flashing comes back there is a problem and you should then contact Dometic service. D C Air out 6. Ice cubes min. 60 mm Air out Ventilation grille miniBar miniCool miniBar miniCool Fill the ice tray up to 4/5 with drinking water, cover with the lid and place the closed ice tray on the icetray shelf. Wipe off any excess water to prevent the ice tray from freezing to the surface.
8.2. Interior light (fig. 6.) Two light-emitting diodes (A) on an electronic PCB illuminate the cooling compartment when the door is opened. Two sensors (B) control whether the door is open or not and the LEDs and the door control as well will work accordingly. A B C Figure 9. 1. Fit the cable with the cable bridge (A) to the side wall on the hinge side by drilling the holes according to Fig. 10. Top of the miniBar A 11 m m B mm mm mm 1 Figure 6. Right side wall (inside) 8.3.
Figure 13. 5. Connect the miniBar to the mains. After opening the door the red LED must be lighten. 6. To reset the LED signal please act according to the steps described at the freestanding version. 9. Reversing the door hang (Fig. 14.
In the event of a fault developing, contact your nearest Service Centre-see local telephone directory. 12. Putting into operation Technical data: Model Type Gross volume Mains operation Input Energy consumption Climate class Refrigerant RH 439LD MB20-60 24,5 litres 100V (AC) 65W 0.7 kWh/24h N 147g H2O+98g NH3 RH 449LD MB20-60 30 litres 100V (AC) 65W 0.8 kWh/24h N 147g H2O+98g NH3 12.1.
Printed by Océ Hungária Kft. 2006. 07. 05.
