User manual

Green and Yellow: Earth
Blue: Neutral
Brown: Live
The wire coloured green and yellow must be
connected to the terminal marked with the letter "E"
or by the earth symbol or coloured green and
yellow.
The wire coloured blue must be connected to the
terminal "N" or coloured black.
The wire coloured brown must be connected to the
terminal marked "L" or coloured red.
10. Customer service
Before you call a service engineer, carry out the
following simple tests:
8
If after checking all the above points, the refrigerator is
still not working satisfactorily, contact your nearest
service engineer. State the problem, model, product-
and serial-number.
GB
Model RH 423LDAG RH 439LDAG RH 449LDAG
Type MB20-60 MB20-60 MB20-60
Gross volume 23 litres 24,5 litres 30 litres
Mains operation 220 - 240V (AC) 220 - 240V (AC) 220 - 240V (AC)
Input 75W 75W 75W
Energy consumption 1,02 kWh/24h 1,15 kWh/24h 1,2 kWh/24h
Climate class N N N
Refrigerant 159g H
2
O+86g NH
3
147g H
2
O+98g NH
3
147g H
2
O+98g NH
3
Problem
The appliance does not cool sufficiently
The appliance does not cool at all.
Possible cause
Too much food to be cooled was put in.
Door is not shut properly.
Internal air circulation is restricted.
CUC system stopped the operation.
Plug is not connected to the mains socket
properly
There is no voltage in the mains socket.
Solution
Put in less food to be be cooled.
Check if the door is shut.
Provide inside cool air circulation.
See operating instruction 5.3.
Check if the connection is
proper.
Check if there is voltage.
(Details of the model, product- and serial-number
are to be found on the data label in the top left of the
inside compartment.)
In the event of a fault developing, contact your
nearest Service Centre-see local telephone
directory.
11. Putting into operation
Technical data:
11.1. Connecting to electrical mains
The appliance may only be operated from
nominal voltage mains as shown on the data
plate. The appliance mains plug may be connected
to a mains socket earthed in accordance with
regulations.
Any electrical work required to install this appliance
should be carried out by a qualified electrician or
competent person.
The manufacturer declines any liability should
these safety measures not be observed.
Electrical Requirements
Before switching on, make sure the electricity
supply voltage is the same as that indicated on the
appliance rating plate.
Only for UK:
The appliance is supplied with a 3 Amp plug fitted.
In the event of having to change the fuse in the plug
supplied, a 3 Amp ASTA approved (BS 1362) fuse
must be used. Should the plug need to be replaced
for any reason, the wires in the mains lead are
coloured in accordance with the following code: