miniBar RH 161 Type: MF20-60 Operating Instructions 207.5192.
Please read these operating instructions carefully before putting the refrigeration unit into operation. If you later sell or dispose of it, please ensure that the new owner receives these operating instructions. Please follow the installation details below carefully Guarantee is valid for products installed as described only. Thank you for choosing our appliance. We are sure it will provide you with trouble-free use.
CONTENTS 1. Unpacking 2. 3. View of the appliance Cleaning 4. Positioning the appliance 4.1. Installation instruction 5. Using the appliance 6. 5.1. Temperature regulation Ice cubes 7. 8. Useful suggestions Defrosting, cleaning and maintenance 9. Changing the lightbulb 10. 11. Reversing the door hang Replacing the decorative door panel 12. 13,. Customer service Putting into operation, technical data 14. 15. Environmental protection information Recycling 13.1.
1. Unpacking After removal from the cardboard packaging, make sure the appliance is not damaged. If you find damage to the appliance resulting from transport, report it immediately to the transportation firm. 2. View of the appliance RH 161 Figure 1. 1. door 2. bottle retainer 3. evaporator 4. sensor 5. thermostat knob 6. hinge plate 7. fixing foot 8. lamp (if available) IN CASE IF YOUR REFRIGERATOR IS EQUIPPED WITH LOCK, DOMETIC RT DO NOT ACCEPT LIABILITY FOR LOSS OR DAMAGE OF KEYS.
3. Cleaning Clean the refrigerator thoroughly at intervals, as necessary. Remove the shelves; these, parts, as well as the cabinet interior and the door should be washed with a warm solution of sodium bi-carbonate. Finally wipe over with a cloth rinsed in warm water only, and dry with a clean cloth. Do not wash any plastic parts in water that is more than hand warm, and do not expose them to dry heat. The outside of the cabinet should be wiped down regularly with a clean, damp cloth.
9. Changing the lightbulb (If available) If the lightbulb needs changing, pull out the plug and proceed as follows: Press the metal reflector to one side and draw the lamp covering backwards. Replace the bulb and push the covering back into place. A new max. 10-watt bulb can be obtained at any service shop. Figure 5. 6. Ice cubes Fill the ice tray to 4/5 with drinking water, and place the ice tray on the ice-tray shelf. Wipe off any excess water to prevent the ice tray from freezing to the surface.
insert the new panel (7), so that the upper edge of the panel runs exactly parallel to the upper edge of the frame. A new panel can be inserted more easily into the upper edge of the frame when the two corners are cut off by approx. 5 x 5 mm (8). Put the frame edge (5) back in place and secure with screws. Place the door on the lower hinge (9), slot the upper hinge into the opening, press together with the door against the housing and secure with the two screws (11).
The wire coloured blue must be connected to the terminal „N“ or coloured black. The wire coloured brown must be connected to the terminal marked „L“ or coloured red. Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath. 14. Environmental protection information The appliance does not contain any CFCs/HCFCs. Ammonia (natural hydrogen and nitrogen compound) is used as a refrigerating agent in the refrigeration unit.
