miniBar RH 131 RH 141 Type: MF20-60 Operating Instructions 207.5184.
Please read these operating instructions carefully before putting the refrigeration unit into operation. If you later sell or dispose of it, please ensure that the new owner receives these operating instructions. Please follow the installation details below carefully Guarantee is valid for products installed as described only. (See chapter 4.1) Thank you for choosing our appliance. We are sure it will provide you with trouble-free use.
C ONTENT S 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. Unpacking View of the appliance Cleaning Positioning the appliance 4.1. Installation instruction Using the appliance 5.1. Temperature regulation Ice cubes Useful suggestions Defrosting, cleaning and maintenance Changing the lightbulb Reversing the door hang Replacing the decorative door panel Changing the feet Customer service Putting into operation, technical data 14.1.
1. Unpacking After removal from the cardboard packaging, make sure the appliance is not damaged. If you find damage to the appliance resulting from transport, report it immediately to the transportation firm. 2. View of the appliance 4 3 3 4 2 2 1 1 5 5 6 6 7 7 RH 131 RH 141 Figure 1. 1. Door lock (if available) 5. Sensor 2. Door 6. Thermostat knob 3. Lamp (if available) 7. Fixing foot 4. Evaporator IN CASE IF YOUR REFRIGERATOR IS EQUIPPED WITH LOCK, DOMETIC ZRT.
3. Cleaning Clean the refrigerator thoroughly at intervals, as necessary. Remove the shelves; these, the cabinet interior and the door should be washed with a warm solution of sodium bi-carbonate. Finally wipe over with a cloth rinsed in warm water only, and dry with a clean cloth. Do not wash any plastic parts in water that is more than hand warm, and do not expose them to dry heat. The outside of the cabinet should be wiped down regularly with a clean, damp cloth.
5. Using the appliance To start the refrigerator connect the plug into a properly earthed socket. The cooling fins should show signs of cooling after about 3 hours. The refrigerator needs about 6 hours at normal ambient temperature to reach 6 °C in the storage compartment. 5.1. Temperature regulation The usual setting required is in the region of 2 to 3 on the thermostat knob (Fig. 5), but this can vary with conditions of load and installation.
Figure 7. 11. Replacing the decorative door panel, (Fig. 8-10) Remove the two screws (1) from the upper hinge of the door. Pull the door together with the hinge away from the housing and up off the lower hinge bolt (2-3). Remove screws (4) and pull off the frame edge (5). Slide the decorative panel (6) out of the door frame and insert the new panel (7), so that the upper edge of the panel runs exactly parallel to the upper edge of the frame.
13. Customer service Before you call a service engineer, carry out the following simple tests: Before you call a service engineer, carry out the following simple tests: Is there a power failure? Check the fuses. Is the plug firmly connected to the socket and is the socket switched on? Check the socket by plugging in another appliance, e.g. a table lamp. Is the thermostat at the correct setting? (normally 3 or 4).
16. Recycling After unpacking the appliance, the packing materials should be delivered to a local collection site. At the end of its useful lifetime, the appliance should be delivered to a specialized collection and reprocessing firm, which reclaims the usable materials. The rest is properly destroyed. Appliances bearing this symbol must be deposited at the designated local reception point for the disposal of electrical and electronic equipment.
Printed by Océ-Hungária Kft. Rev.: 2006. 11. 08.
