miniBar R RH 430LD RH 430LG RH 440LD RH 440LG RH 460LD RH 460LG !:/<+>381 68=>->398= GB
Please read these operating instructions carefully before putting the refrigeration unit into operation. If you later sell or dispose of it, please ensure that the new owner receives these operating instructions. Please follow the installation details below carefully Guarantee is valid for products installed as described only. (See chapter 4.1) Thank you for choosing our appliance. We are sure it will provide you with trouble-free use.
������� � �� �� �� �� ��������� ��������������������� �������� ������������������������� ���� ������������������������ �� ������������������� ���� ���������������������� 5.2.
1. Unpacking After removal from the cardboard packaging, make sure the appliance is not damaged.If you find damage to the appliance resulting from transport, report it immediately to the transportation firm. 2. View of the appliance Fig.1 1. Door 5. Thermostat knob 2. Lamp 6. Fixing foot 3. Evaporator 4. Sensor lN CASE lF YOUR REFRIGERATOR IS EQUlPPED WlTH LOCK, DOMETIC DO NOT ACCEPT LlABlLlTY FOR LOSS OR DAMAGE OF KEYS. HOWEVER WE WOULD BE HAPPY TO SUPPLY A COMPLETE LOCK AND KEY REPLACEMENT.
3. Cleaning Clean the refrigerator thoroughly at intervals, as necessary. Remove the shelves; these, the cabinet interior and the door should be washed with a warm solution of sodium bi-carbonate. Finally wipe over with a cloth rinsed in warm water only, and dry with a clean cloth. Do not wash any plastic parts in water that is more than hand warm, and do not expose them to dry heat. The outside of the cabinet should be wiped down regularly with a clean, damp cloth.
'=381 >2/ +::63+8-/ To start the refrigerator,connect the plug to the socket outlet and switch on the socket. The cooling fins should show signs of cooling after about 3 hours. The refrigerator needs about 6 hours at normal ambient temperature to reach 6 °C in the storage compartment. &/7:/<+>?398 You can set a temperature between max. and min. by rotating the knob (Fig.5). Turn to max. will produce a colder temperature and higher energy consumption; and turn to min.
Distance to cupboard door (A) 1. mm 4.Re-assemble the case in the reverse order. A new 10-watt bulb can be obtained at Dometic. $/@/<=381 >2/ .99< 2+81 (Fig.7) Lay the appliance on its back. Remove the 8 screws (1). Remove the door, together with the two hinges (2), from the housing. Remove the two cover caps (3) from the housing and place them in the open hinge holes in the housing.
Failure : No cooling (the cooling unit is warm). Possible Cause Self Help Authorised Service a.) The device is a.) not level. Leakage test ? b.) The device was b.) only switched on a short while ago. c.) Defective cooling unit. Level the device using a spirit level. Switch on the device and let it run for 5-6 hours. c.) Exchange device. Failure : Poor cooling performance. Possible Cause Self Help Authorised Service Figure 8. a.) Check that the a.
988/->381 >9 /6/-><3-+6 7+38= The appliance may only be operated from nominal voltage mains as shown on the data plate. The appliance mains plug may be connected to a mains socket earthed in accordance with regulations. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. &2/ 7+8?0+->?C =29?6. >2/=/ =+0/>C 7/+=? ,/ 9,=/<@/.
Suites 2207-2211,22/F,Tower1, 2461 1386 Fax: (+852)2466 5553 www.dometic.com Subject to change without notice.