INSTALLATION & OPERATING INSTRUCTIONS RA/RM-1D RA/RM-2D RGE 300 822 70 62-03 RGE 400 MO-M 0802
INTRODUCTION Contents We are pleased that you have chosen this refrigerator and hope you will derive much satisfaction from using it, but first a few well-meant words of advice: • It is important to read through these instructions carefully before using the refrigerator. • To ensure good refrigeration and economical operation, the refrigerator must be installed and used as described in these instructions.
OPERATING INSTRUCTIONS Electric operation Set the energy selector (A) to position I. CONTROLS REGULATING THE TEMPERATURE The position number refers to fig. 1. It will take several hours for the refrigerator to reach normal operating temperature. A thermostat controls the temperature of the main compartment of the refrigerator. The thermostat knob (B) should be set at 3-5. If a lower (colder) temperature is desired set the thermostat to a higher figure. FOOD STORAGE Always keep food in closed containers.
ICE-MAKING iF THE ‘FRIDGE FAILS TO WORK Fill the ice tray just below the brim with drinking water and place it on the freezer shelf. It is possible to make ice faster by turning the control knob temporarily to its highest value but do not forget to turn it back to its regular setting afterwards as the refrigerator might otherwise become too cold. Check the following points before calling a service technician: • That the STARTING THE REFRIGERATOR instructions have been followed.
TECHNICAL DATA RGE 300 From the side RGE 400 Overall dimensions Height 1175 1612 mm Width 592 592 mm Depth 623 623 mm Gross 146 224 litres Net 137 209 litres 15 47 litres 58 76 kg Input 240 V 175 300 watt Energy consumption/24h 2.2 3.9 kWh Input max 1.14 1.
LP GAS CONNECTION The refrigerator is designed for operation on LP gas, the pressure of which must be 2.72 kPa for Propane. Check that this is stated on the data plate. The refrigerator is not designed for operation on town gas or natural gas. Check that the gas supplied to the refrigerator is at the correct pressure. See the reducing valve on the LP gas container.
0802
