User manual

ManualsBrandsDometic ManualsOtherRC185GET

(3)

OPERATING AND INSTALLATION INSTRUCTIONS FOR

ELECTROLUX FREEZERS

INTRODUCTION

We are pleased that you have chosen this freezer

and hope you will derive much satisfaction from

using it, but first a few well-meant words of advice:

It is important to read through these instructions

carefully before using the freezer.

To ensure good refrigeration and economical

operation, the freezer must be installed and used

as described in these instructions.

The freezer is designed for operation in homes,

locations, cottages, holiday homes, chalets or

similar.

TRANSIT DAMAGE

Inspect the freezer for damage. Transit damage

must be reported to whoever is responsible for

delivery not later than seven days after the freezer

was delivered.

DATA PLATE

Check the data plate, inside of the freezer, to

ensure that you have received the right model.

The right gas pressure is 28 - 30 mbar

The data plate contains e.g. the following details:

Product no. 9211605..

Model no. RC185…

Serial no. …………………

Voltage …………....volts

Wattage ……...……watts

Fuel ………………….

Since these details will be needed if you have to

contact service personnel, it is a good idea to make

a note of them here.

CONTENTS

OPERATING INSTRUCTIONS…………..4

CONTROLS……………………………………..4

STARTING THE FREEZER……………………4

REGULATING THE TEMPERATURE………..4

FOOD STORAGE……………………………….4

DEFROSTING……………………………………5

CLEANING THE FREEZER…………………….5

TURNING OFF THE FREEZER ……………….5

IF THE FREEZER FAILS TO WORK………….5

MAINTENANCE………………………………..6

REGULAR MAINTENANCE……………………6

SOME USEFULL HINTS………………………..6

SERVICE………………………………………….6

TECHNICAL DATA………………………………6

INSTALLATION INSTRUCTIONS…………6

PLACEMENT OF THE FREEZER …………….6

LP GAS CONNECTION ………………………..7

ELECTRICAL CONNECTION …………………7

Summary of content (5 pages)

PAGE 1
OPERATING AND INSTALLATION INSTRUCTIONS FOR ELECTROLUX FREEZERS INTRODUCTION We are pleased that you have chosen this freezer and hope you will derive much satisfaction from using it, but first a few well-meant words of advice: CONTENTS It is important to read through these instructions carefully before using the freezer. CONTROLS……………………………………..4 OPERATING INSTRUCTIONS…………..
PAGE 2
OPERATING INSTRUCTIONS CONTROLS 3. Check that the electricity supply is switched off at the main supply. 4. Set the thermostat knob (A) to the coldest setting (turn clock wise). 5. Press the flame failure device button (B) and turn it to the open position (turn anti – clock wise). 6. Keeping the flame failure device button (B) pressed, press the igniter (D) repeatedly until the flame ignites. This will be indicated by the needle of the flame indicator (C) that will start rising. 7.
PAGE 3
and it is important to follow the instructions on the individual packets. should only be cleaned with soap and water and then thoroughly dried. Never put bottles or cans of fizzy drinks in the freezer during normal operation as they might burst when freezing. TURNING OFF THE FREEZER When using this freezer as a bottle cooler the thermostat setting must be adjusted to prevent bottles from freezing. If the freezer is not to be used for some time: 1.
PAGE 4
5. Incorrect electrical source – confirm that the main electrical supply is the same as that specified on the data label. 6. The ambient temperature is too high. 7. Too much food is loaded at one time. 8. More than one source of energy is used at the same time. If the freezer still does not work properly, call a service technician. The sealed cooling system must not be opened, since it contains corroding chemicals under high pressure.
PAGE 5
The freezer should be adjusted to be level from left to right as well as from the front to the back. Place the spirit level supplied, on the bottom of the tank of the freezer to confirm whether it is level. A level floor will ensure that the fridge is level.