Instruction Manual

EN
Installing the device PI8022, PI8023
14
6.4 Connecting the device to the power supply (PI8023)
➤ Connect the device as shown (fig. 8).
➤ Add a 1 A fuse in the plus line near the battery.
6.5 Testing the device
➤ Ignite all burners both individually and concurrently to ensure correct operation
of gas valves, burners and ignition.
➤ Turn gas taps to low flame position and observe the stability of the flame for each
burner individually and concurrently.
✔ Depending on the type of gas used, the appearance of the flame is as follows:
– Propane: Flame with blue centre and well-defined contour
– Butane: Flame with light yellow tips when igniting the burner, gradually
intensifying as the burner heats
➤ Ensure correct operation of the flame failure protection.
12 V
1 A
2 x 0,5 mm
2
red
black

d200 cm
8
DometicPI8002-PI8022-PI8023_IOM_4445103105_APAC(en)_xxxx-xx-xx.book Seite 14 Mittwoch, 20. Januar 2021 10:10 22