Product Manual

Using the appliance PJS118
EN
12
Charging with the home charger
➤ Connect the home charger (fig. 4 1, page 11) to the connection socket (fig. 1 10, page 7).
➤ Connect the home charger to the AC mains.
✓ The input indicator is shown in the display, see chapter “Display” on page 9.
The charging function automatically stops when the jump starter is fully charged.
Charging with the car charger
➤ Connect the car charger (fig. 4 2, page 11) to the connection socket (fig. 1 10, page 7).
➤ Connect the car charger to the socket in the car.
✓ The input indicator is shown in the display, see chapter “Display” on page 9.
Checking the charge level
➤ Press the power button (fig. 1 3, page 7).
✓ The display shows the state of charge between 0% (discharged) to 100% (fully charged), see
chapter “Display” on page 9.
6.4 Using the LED work light
The LED work light (fig. 3 1, page 9) can be used with three different functions. 
The different functions can be changed in sequence by pressing the power button (fig. 1 3,
page 7): Continuous light, strobe light, SOS signal - OFF
LED continuous light
➤ Press and hold the power button for 3 seconds.
✓ The LED work light lights up continuously.
Strobe light
➤ Press the power button again.
✓ The LED work light is flashing in constant intervals.
SOS signal
➤ Press the power button again.
✓ The LED work light is flashing the SOS signal pattern.
OFF
➤ Press the power button again.
✓ The LED work light is switched off.