Product Manual

EN
PGE121 Maintenance
35
➤ Fill to the upper limit of the oil filler neck with the recommended oil, see chapter
“Technical data” on page 48.
➤ If the wet line on the oil level indicator (fig. r 3, page 34) is between "L" posi-
tion and "H" position, the oil level is OK. If the oil is below "L" position, the oil
level is too low.
➤ Fill to the upper limit of the oil level indicator with the recommended oil, see
chapter “Technical data” on page 48.
➤ Tighten the dipstick (fig. r 2, page 34) and reinstall the oil maintenance cover
(fig. r 1, page 34).
Change engine oil
I
➤ Place the generator on a flat level surface.
➤ Make sure, the engine switch (fig. 6 8, page 12) is in “OFF“ position.
➤ Before tipping the engine to drain the used oil, drain the fuel in the carburetor to
prevent fuel leakage, see chapter “Long time storage >6 month” on page 43.
➤ Turn the fuel tap (fig. 6 1, page 12) to “OFF“ position and close the fuel cap
tightly.
➤ Make sure the fuel cap vent lever is turned to position “OFF“ to reduce the risk of
fuel leakage.
➤ Open the oil maintenance cover (fig. s 1).
➤ Place a suitable oil pan under the oil filler neck (fig. s 3) to catch the used oil.
NOTE
Drain the engine oil while the engine is warm.
s