Product Manual

EN
Maintenance PGE121
34
9.2 Engine oil check/change
The engine is equipped with a low oil sensor that will prevent the engine from run-
ning if the oil level falls below a critical level.
Check engine oil
➤ Place the generator on a flat level surface.
➤ Make sure, the engine switch (fig. 6 8, page 12) is in “OFF“ position.
➤ Turn the fuel tap (fig. 6 1, page 12) to “OFF“ position and close the fuel cap
tightly.
➤ Turn the fuel cap vent lever to the “OFF“ position.
➤ Open the oil maintenance cover (fig. r 1).
➤ Remove the dipstick (fig. r 2) and wipe it clean.
➤ Check the oil level by inserting the dipstick (fig. r 3, page 34) into the filler
neck without screwing it in.
✓ The engine oil level has to be between the lower and upper marker on the oil
level indicator.
No. in
fig. r
Description
1 Oil maintenance cover
2Dipstick
3 Oil level indicator
L Low oil level
H High oil level
r