Operating instructions

SinePower Safety instructions

2.2 Safety when installing the device

z Ensure the device is standing firmly.

The device must be set up and fastened in such a way that it cannot tip

over or fall down.

z Take the precautions necessary to ensure that children cannot interfere

with operation. Dangerous situations may occur which cannot be recog-

nised by children!

z Do not expose the device to a heat source (such as direct sunlight or heat-

ing). Avoid additional heating of the device in this way.

Electrical cables

z If cables have to be fed through metal walls or other walls with sharp edg-

es, use ducts or wire bushings to prevent damage.

z Do not lay cables which are loose or bent next to electrically conductive

material (metal).

z Do not pull on the cables.

z Do not lay the 230 V mains cable and the 12/24 V DC cable in the same

duct.

z Fasten the cables securely.

z Lay the cables so that they cannot be tripped over or damaged.

2.3 Operating the appliance safely

z Operate the device only if you are certain that the housing and the cables

are undamaged.

z Make sure the air inlets and outlets of the device are not covered.

z Ensure good ventilation.

z Do not connect the 230 V output of the inverter (fig. 1 3, page 3) to a

different 230 V source.

z Even after the fuse triggers, parts of the inverter remain live.

z Always disconnect the power supply when working on the device.

_MSP160_MSP350.book Seite 23 Freitag, 9. September 2011 4:44 16