Installation Guide

21
EN
Harrier series Installation
➤ Fasten the ADB to the ceiling through to the roof air conditioner with the
4 bolts supplied.
See fig. h
A
➤ Tighten the screws using a torque spanner and a fastening torque of
2.5 Nm ±0.3 Nm.
8.5.5 Communication cable
➤ Connect the communication 4 pin plug into the socket on the side of the
display (2) in the ADB.
➤ Ensure the cable is located into the small opening away from the filter area.
➤ Secure excess cable into the holders.
➤ Push the filter back fully in.
NOTICE! Risk of damage
Tighten to the specified torque. Do not overtighten!
A
2.5±0.3 Nm
h
Harrier-Lite_INM.book Seite 21 Donnerstag, 30. April 2020 3:45 15