miniCool EA 3120 Type: MF20-60 Operating Instructions 207.5184.
Please read these operating instructions carefully before putting the refrigeration unit into operation. If you later sell or dispose of it, please ensure that the new owner receives these operating instructions. Please follow the installation details below carefully Guarantee is valid for products installed as described only. (See chapter 4.1) Thank you for choosing our appliance. We are sure it will provide you with trouble-free use.
CONTENT S 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. Unpacking View of the appliance Cleaning Positioning the appliance 4.1. Installation instruction Using the appliance 5.1. Temperature regulation Useful suggestions Defrosting, cleaning and maintenance Changing the lightbulb Reversing the door hang Replacing the decorative door panel Assembly of door handle Customer service Putting into operation, technical data 13.1.
1. Unpacking After removal from the cardboard packaging, make sure the appliance is not damaged. If you find damage to the appliance resulting from transport, report it immediately to the transportation firm. 2. View of the appliance EA 3120 Figure 1. 1. Door 5. Sensor 2. Door lock 6. Lamp (if available) 3. Thermostat knob 7. Door racks 4. Evaporator IN CASE IF YOUR REFRIGERATOR IS EQUIPPED WITH LOCK, DOMETIC RT DO NOT ACCEPT LIABILITY FOR LOSS OR DAMAGE OF KEYS.
3. Cleaning Clean the refrigerator thoroughly at intervals, as necessary. Remove the shelves; these, the cabinet interior and the door should be washed with a warm solution of sodium bi-carbonate. Finally wipe over with a cloth rinsed in warm water only, and dry with a clean cloth. Do not wash any plastic parts in water that is more than hand warm, and do not expose them to dry heat. The outside of the cabinet should be wiped down regularly with a clean, damp cloth.
warmer temperature. The effect of any adjustment can be checked by means of the thermometer after leaving the refrigerator operating for a further period to settle down again. Figure 4. 6. Useful suggestion 9. Reversing the door hang, (Fig. 6) Lay the appliance on its back. Remove the 8 screws (1). Remove the door, together with the two hinges (2), from the housing. Remove the two cover caps (3) from the housing and place them in the open hinge holes in the housing.
Place the door on the lower hinge (9), slot the upper hinge into the opening, press together with the door against the housing and secure with the two screws (11). This refrigerator is equipped with overheating protection. An authorised service engineer can check whether this has been triggered or not. In the event of a fault developing, contact your nearest Service Centre-see local telephone directory. 13. Putting into operation Technical data: Figure 9. 11. Assembly of door handle (Fig. 10.
The appliance does not contain any CFCs/HCFCs. Ammonia (natural hydrogen and nitrogen compound) is used as a refrigerating agent in the refrigeration unit. The ozone-friendly cyclopentane is activated as a motive agent for the PU foam insulation. Sodium chromate is used for corrosion protection (less than 2 weight % of the coolant). After unpacking the appliance, the packing materials should be delivered to a local collection site.