miniCool EA 3210 EA 3200 EA 0610 EA 0600 EA 0611 EA 0601 EA 0612 EA 0602 RA 0650 Type: MF20 - 60 OoFT No: N19548 207.5186.
Please read these operating instructions carefully before putting the refrigeration unit into operation. If you later sell or dispose of it, please ensure that the new owner receives these operating instructions. Please follow the installation details below carefully Guarantee is valid for products installed as described only. Thank you for choosing our appliance. We are sure it will provide you with trouble-free use.
C ONTENT S 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. Unpacking View of the appliance Cleaning Positioning the appliance 4.1.Installation instruction Using the appliance 5.1.Temperature regulation Ice cubes Useful suggestions Defrosting, cleaning and maintenance Changing the lightbulb Reversing the door hang Replacing the decorative door panel Assembly of door handle Customer service Putting into operation, technical data 14.1.
1. Unpacking After removal from the cardboard packaging, make sure the appliance is not damaged. If you find damage to the appliance resulting from transport, report it immediately to the transportation firm. 2. View of the appliance 7 7 EA 3210 EA 3200 Figure 1. 1. door 2. bottle retainer 3. evaporator 4. thermostat knob 5. sensor 6. freezer** 7. fixing foot 8. lamp IN CASE IF YOUR REFRIGERATOR IS EQUIPPED WITH LOCK, DOMETIC ZRT DO NOT ACCEPT LIABILITY FOR LOSS OR DAMAGE OF KEYS.
3. Cleaning 6. Air passing through the duct must not be preheated by any source of heat Clean the refrigerator thoroughly at intervals, as 7. Ventilation grills, if used, must have an free necessary. Remove the shelves; these, the openings of at least 200cm2 each cabinet interior and the door should be washed with a warm solution of sodium bi-carbonate. Finally wipe over with a cloth rinsed in warm water only, and dry with a clean cloth.
5. Using the appliance To start the refrigerator connect the plug to the socket outlet and switch on the socket. The cooling fins should show signs of cooling after about 3 hours. The refrigerator needs about 6 hours at normal ambient temperature to reach 6 °C in the storage compartment. 5.1. Temperature regulation The usual setting required is in middle of the setting range on the thermostat knob (Fig. 5-6), but this can vary with conditions of load and installation.
remove the two upper left-hand screws and detach the covering plate e by pulling it forward detach the upper hinge and mount it on the opposite side remove the hinge bolt and screw it in from below insert the covering plate in the upper right-hand corner by pushing it in and secure it with the two screws position the door on the upper hinge bolt and mount the lower hinge ensure the door can move freely and the seal is correctly positioned. Figure 10. Figure 11. Figure 8. 12.
to its usual position and the refrigerator should start cool again. Has the ventilation become obstructed? If after checking all the above points, the refrigerator is still not working satisfactorily, contact your nearest service engineer. State the problem, model, productand serial-number. (Details of the model, product- and serialnumber are to be found on the data label in the top left of the inside compartment.) This refrigerator is equipped with overheating protection.