miniCool EA 0600 Type: MF20-60 Operating Instructions 207.5186.
GB Please read these operating instructions carefully before putting the refrigeration unit into operation. If you later sell or dispose of it, please ensure that the new owner receives these operating instructions. Please follow the installation details below carefully Guarantee is valid for products installed as described only. Thank you for choosing our appliance. We are sure it will provide you with trouble-free use.
GB CONTENTS 1. Unpacking 2. View of the appliance 3. Cleaning 4. Positioning the appliance 4.1. Installation instruction 5. Using the appliance 5.1. Temperature regulation 6. Useful suggestions 7. Defrosting, cleaning and maintenance 8. Changing the lightbulb 9. Reversing the door hang 10. Replacing the decorative door panel 11. Changing the feet 12. Assembly of door handle 13. Customer service 14. Putting into operation, technical data 14.1. Connecting to electrical mains 15.
GB 1. Unpacking After removal from the cardboard packaging, make sure the appliance is not damaged. If you find damage to the appliance resulting from transport, report it immediately to the transportation firm. 2. View of the appliance EA 3200 Figure 1. 1. door 2. bottle retainer 3. evaporator 4. thermostat knob 5. sensor 6. freezer 7. lamp IN CASE IF YOUR REFRIGERATOR IS EQUIPPED WITH LOCK, DOMETIC RT DO NOT ACCEPT LIABILITY FOR LOSS OR DAMAGE OF KEYS. HOWEVER A COMPLETE LOCK CAN BE SUPPLIED.
GB 3. Cleaning Clean the refrigerator thoroughly at intervals, as necessary. Remove the shelves; these, the cabinet interior and the door should be washed with a warm solution of sodium bi-carbonate. Finally wipe over with a cloth rinsed in warm water only, and dry with a clean cloth. Do not wash any plastic parts in water that is more than hand warm, and do not expose them to dry heat. The outside of the cabinet should be wiped down regularly with a clean, damp cloth.
GB thermometer after leaving the refrigerator operating for a further period to settle down again. 6. Useful suggestion Do not overfill the appliance. It is advisable to leave some space between the products in the cabinet to ensure efficient and even cooling. If the shelves are packed too tightly there may be unacceptable temperature variations. 7.
GB 12. Assembly of door handle (Fig. 11) Figure 7. Figure 11. 13. Customer service Figure 8. Figure 9. 11. Changing the feet (Fig. 10) Should you wish to install your miniCool, you will not need the 40-mm feet. After having removed the 40-mm feet, you can then re-attach the 12-mm feet, located inside the 40mm feet, to the front and rear fixing points. The 40-mm feet and the 4 remaining screws should be retained for future use.
GB The manufacturer declines any liability should these safety measures not be observed. Electrical Requirements Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. Only for UK: The appliance is supplied with a 3 Amp plug fitted. In the event of having to change the fuse in the plug supplied, a 3 Amp ASTA approved (BS 1362) fuse must be used.
