miniCool EA 3210 EA 0610 EA 0611 EA 0612 RA 0650 EA 3200 EA 0600 EA 0601 EA 0602 EA 3255 EBP Operating Instructions 207.5167.
Please read these operating instructions carefully before putting the refrigeration unit into operation. If you later sell or dispose of it, please ensure that the new owner receives these operating instructions. Please follow the installation details below carefully Guarantee is valid for products installed as described only. (See chapter 4.1) Thank you for choosing our appliance. We are sure it will provide you with trouble-free use.
CONTENT S 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. Unpacking View of the appliance Cleaning Positioning the appliance 4.1. Installation instruction Using the appliance 5.1. Temperature regulation Ice cubes Useful suggestions Defrosting, cleaning and maintenance Changing the lightbulb Reversing the door hang Replacing the decorative door panel Changing the feet Assembly of door handle Customer service Putting into operation, technical data 15.1.
1. Unpacking After removal from the cardboard packaging, make sure the appliance is not damaged. If you find damage to the appliance resulting from transport, report it immediately to the transportation firm. 2. View of the appliance EA 3210 EA 3200 EA 3280 Figure 1. 1. door 5. sensor 2. bottle retainer 6. freezer** 3. evaporator 7. freezer*** 4. thermostat knob 8. lamp IN CASE IF YOUR REFRIGERATOR IS EQUIPPED WITH LOCK, DOMETIC RT DO NOT ACCEPT LIABILITY FOR LOSS OR DAMAGE OF KEYS.
3. Cleaning Clean the refrigerator thoroughly at intervals, as necessary. Remove the shelves; these, the cabinet interior and the door should be washed with a warm solution of sodium bi-carbonate. Finally wipe over with a cloth rinsed in warm water only, and dry with a clean cloth. Do not wash any plastic parts in water that is more than hand warm, and do not expose them to dry heat. The outside of the cabinet should be wiped down regularly with a clean, damp cloth.
3. Ventilation must be provided as shown in alternatives A, B, C or D (fig 2-3) 4. The ventilation duct must at least measure 105mm x the width of the refrigerator 5. Only the entire cooling unit must project into the duct as shown 6. Air passing through the duct must not be preheated by any source of heat 7. Ventilation grills, if used, must have openings of at least 200cm2 each During installation, please ensure the mains plug is accessible at all times. 5.
6. Ice cubes Fill the ice tray to 4/5 with drinking water, and place the ice tray on the ice-tray shelf. Wipe off any excess water to prevent the ice tray from freezing to the surface. To speed up the making of ice cubes, turn the thermostat to position MAX for a short while. Remember to turn the dial to its normal setting when the ice cubes are frozen. To remove the cubes from the ice tray, hold it under running water. The ice cubes can now be taken out easily. 7.
9. Changing the lightbulb (If available) If the lightbulb needs changing, pull out the plug and proceed as follows: Press the metal reflector to one side and draw the lamp covering backwards. Replace the bulb and push the covering back into place. A new max. 10-watt bulb can be obtained at any service shop. 10. Reversing the door hang, (Fig.
EA 3280 (Fig. 12) A door decoration plate can be changed or fitted quite simply. detach and remove the plastic strip from the frame at one end pull the door plate slightly downwards pull the plate from the middle to the outside until it can be detached on the side fit in the new plate and push it upwards attach plastic strip. 12. Changing the feet (Fig. 13) Should you wish to install your miniCool, you will not need the 40-mm feet.
15. Putting into operation Technical data: Model Type Gross volume Mains operation Input Energy consumption Climate class Refrigerant EA 3210 EA 0610, EA 0611 EA 0612, RA 0650 MF20-60 60 litre 220 - 240V (AC) 115W 1.3 kWh/24h N 525g NH3 +H2O EA 3200 EA 0600 EA 0601 EA 0602 EA 3205 EBP MF20-60 60 litre 220 - 240V (AC) 95W 1,4 kWh/24h N 540g NH3 +H2O 15.1 Connecting to electrical mains The appliance may only be operated from nominal voltage mains as shown on the data plate.
16. Environmental protection information The appliance does not contain any CFCs/HCFCs. Ammonia (natural hydrogen and nitrogen compound) is used as a refrigerating agent in the refrigeration unit. The ozone-friendly cyclopentane is activated as a motive agent for the PU foam insulation. Sodium chromate is used for corrosion protection (less than 2 weight % of the coolant). 17. Recycling After unpacking the appliance, the packing materials should be delivered to a local collection site.
Printed by Xerox Hungary Ltd. Rev.: 2003.12. 05.
