Technical data

Summery of Models
Face lifting models and Greenline models are the latest generation of
miniBars/miniCools and consumes approximately 40% less energy than its
predecessors.
RH 430LD RH 330LD RH 236LD
RH 440LD RH 340LD RH 237LD
RH 441LD RH 341LD RH 238LD
RH 460LD RH 360LD RH 252LD
RH 461LD RH 361LD RH 255LD
RH 456LD/LDE RH 356LD/LDE RH 300LD
RH 455LD RH 355LD RH 226LD
RH 436D RH 136D -
RH 447D RH 137D -
- EA 330/L -
- EA 355/L -
- EAW 3220 -
Changes Face-lifting models to Greenline models:
Automatic defrost -cycle and design
Changes Greenline models to Previous models: cooling unit, the heating
cartridge, lighting, insulation and electronic controls (Fuzzy Logic).
Electronics
Fuzzy Logic
All Greenline models and Facelifting models maintain a con-
stant temperature level which has been set at the beginning
of operation. This temperature level is controlled by
electronic intelligence in an energy-saving way.
Unlike conventional appliances, the electronic control
component does not switch on and off but controls (clocks)
the cooling units heating power in a way which does not
require system circulation to be interrupted.
The electronic controls sensor (A) is an air sensor. This means that the
sensor can react directly to the temperature inside the cooling appliance.
Fuzzy Logic with 2 sensors
By means of the second sensor the electronics carries out a leak detection
test. If leaks or blockages in the cooling unit are recognised the miniBar is
shut off by the electronics. The test is done after every defrost cycle
(every 24 hours).
After a Power-On-Reset, the controllers software runs a self test routine to
check the function of the sensors. The result of the test is shown with the
length of the first duty-cycle of the heating element (jumper X4).
There are four different states which are shown in the following table:
3
2.0
1.0
Face lifting Greenline Models Previous Models
A
2.1
2.2