Operating instructions

6
EN
D21 Drop-in Cooktop
4.2 Placing your cooktop
Inside installation
2
Cooktop
Screw
Nylon
Washer
Corner
Piece
Drilled Hole
Counter
Cutout
➤ Locate and cut the opening in the countertop
according to the dimensions in "4.1
Constructing the cabinet" on page 5.
➤ Drill holes in the countertop to match the
location of the screw holes on the Cooktop.
➤ Place one corner piece (supplied) at each corner
of the opening, so that the lip of the corner
piece is flat against the countertop.
➤ Insert the screws and nylon washers (supplied)
to install the Cooktop.
➤ Place the Cooktop into the opening so that is
rests on top of the corner pieces. Hand-tighten
the screws to the countertop.
➤ Verify the Cooktop is level from side to side and
front to rear.
➤ Tighten the screws to secure the Cooktop to
the countertop using a #2 screwdriver. Do not
overtighten.
Outside installation
3
RV Exterior
Cooktop
I
Do not store the Cooktop outside.