Installation Instructions

EN
S7P Using the window
7
➤ Fasten the window using the fastening bolts and the appropriate securing clips.
Firstly fasten the clips on the left and right at the bottom.
I
➤ Remove the protective film from both sides of the window glass.
➤ After installing, check the wall window works properly.
8 Using the window
8.1 Using S7P
Opening the window (fig. 7)
➤ Proceed as follows for each rotary bolt:
Turn the rotary bolt by 90°.tary
➤ Tilt the window pane outwards to the desired opening angle.
Closing the window (fig. 7)
➤ Close the window slowly.
➤ Proceed as follows for each rotary bolt:
Turn the rotary bolt by 90°.
9 Maintaining and cleaning the window
A
➤ Put talcum powder on the rubber seal.
NOTE
If a window frame guide rail does not fit evenly against the vehicle wall,
then you must use more clips, where required, than are specified in the
table.
NOTICE!
Do not use sharp or hard objects for cleaning as these may damage the
window glass.
Only use cleaning agents that are approved by the manufacturer. Acrylic
glass polish (item no. 9600000128), special polishing cloth (item
no.9600000130) and acrylic glass cleaning agent (item
no.9600000129).
S7P-IO-16s.book Seite 7 Donnerstag, 23. Februar 2017 9:13 21