Installation Instructions

EN
Installing S4 S4
8
See fig. 7
A
➤ Seal the outer frame with a flexible non-hardening sealing compound (e.g.
SikaLastomer-710).
See fig. 8
➤ Place the outer frame in the middle of the wall section.
➤ Press the outer frame slightly onto the wall so that the packing compound
spreads out.
➤ Place the inner frame into the support strips on the outer frame and attach
it with the appropriate fastening screws (1).
Only fasten the screws slightly by hand.
(max. torque 3 Nm)
➤ Check that the roller blinds can move freely.
If the roller blinds cannot move freely, undo the screws (1) slightly.
➤ Cover the screw holes with the caps (2).
➤ Remove the protective film from both sides of the acrylic glass.
I
➤ After installing, check the wall window works properly.
➤ If necessary, enter the new weight in the vehicle documents.
NOTICE!
Observe the sealant manufacturer's instructions.
NOTE
If the protective film is exposed to sunlight for too long, it cannot
be taken off without leaving a residue.