Product Manual

EN
Installing the Midi Heki Midi Heki roof light
8
Only electric version:
!
A
➤ Lay the power supply line in the middle on the long side, where the hinges
should go.
See
fig. 5
➤ Check that the roof light has sufficient space around it (approx.1 to 2 mm) in the
wall section.
See
fig. 6
➤ Clean the roof opening in the mounting area.
See
fig. 7
A
➤ Seal the mounting frame with a flexible non-hardening sealing compound (e.g.
SikaLastomer-710).
See
fig. 8
➤ Check the direction of travel when installing.
You can fit the roof light sideways (hinge-side at front in direction of travel) or
lengthways (hinge-side on left or right in direction of travel).
➤ Place the outer frame in the middle of the roof opening.
I
➤ Press the outer frame in the roof slightly so that the packing compound spreads
out.
WARNING! Beware of injury
Disconnect the vehicle power supply before you begin and make sure it
cannot be restarted.
NOTICE!
Make sure that you do not damage any cables during installation.
NOTICE!
Observe the sealant manufacturer's instructions.
NOTE
Electric version: Pay attention to the power supply lines.
Midi-Heki--IO-16s.book Seite 8 Freitag, 10. Februar 2017 5:29 17