Product Manual

EN
Midi Heki roof light Installing the Midi Heki
11
See fig. d
➤ Clip on the ventilation grille.
It needs to click in.
➤ Remove the protective film from both sides of the acrylic glass.
I
➤ After installing, check the roof light works properly.
➤ If necessary, enter the new vehicle height and weight in the vehicle documents.
7.3 Geared version
See fig. b
➤ Fasten the inner frame using the two screws 4 x 20 mm.
See fig. c
➤ Insert the appropriate adapter part for the roof thickness for the hand crank on the
drive sprocket:
➤ Put the hand crank (3) to the closed position.
Position the crank in such a way that when folded, a light pre-load is noticeable.
A
➤ Place the ventilation grille in the inner frame.
NOTE
If the protective film is exposed to sunlight for too long, it cannot be
taken off without leaving a residue.
No. Wall thickness Adapter part colour
1 25 – 42 mm Grey
2 43 – 60 mm Black
NOTICE!
Hold the hand crank in the open position when placing the ventilation
grille on the inner frame, otherwise the position of the hand crank will be
misaligned with the hexagon part.
Midi-Heki--IO-16s.book Seite 11 Freitag, 10. Februar 2017 5:29 17