Product Manual

EN
Troubleshooting CSO103
16
➤ Check the condition of the gas hose.
Replace the hose line if the material is brittle or porous.
➤ Tightly screw the regulator by hand into the new cylinder.
7 Troubleshooting
Due to unforeseen circumstances the appliance may not operate as designed.
Indications of this are flashing back in the burner, large soft yellow flames, flames lift-
ing extensively away from the burner and the appliance not igniting or remaining
alight.
➤ In these cases, check your gas supply to ensure there is sufficient gas, no leaks
and the valves are opened sufficiently for use. If this is the case and the problem/s
still persists, you will need to contact a suitably qualified authorized person to ser-
vice your appliance.
Repairs to the gas supply parts on the device may only be carried out by a qualified
technician.
➤ Shut off the gas supply immediately if a fault occurs.
➤ Check again that the device has been assembled correctly and the parts are
undamaged, especially the gas hose.
➤ Replace the damaged parts.
➤ Only use the device again once all the faults have been rectified.
8 Cleaning and maintenance
!
Cleaning the device
➤ Proceed as shown (fig. 0, page 8).
Cleaning the oven tube burner
➤ Proceed as shown (fig. a, page 8).
CAUTION! Beware of burns
The device is very hot when you use it. Leave the device to cool down
before you clean, pack up or transport it.
CSO103_IOM_APAC(en).book Seite 16 Donnerstag, 5. März 2020 4:28 16