User manual
KITS
Each kit contains two shelves and shelf supports.
STORING THE WINE
Bottles should be stored in your wine cellar accord-
ing to their size (diameters and heights.) Take these
differences into account when storing your wine
and avoid mixing the bottles.
bottles that can be stored in a wine cellar that is
The sliding shelves and the storage shelves can be
placed in several positions depending on the size of
your wine cellar.
It is important to store bottles on their side in order
for the cork to remain in contact with the wine.
Place bottles top to bottom in the cellar for
optimum volume use.
See Appendix A for information about the best
If the wine cellar fails to work, check the following
points before calling a service technician:
Is the fuse of power supply intact?
Is the plug properly inserted in its socket?
Is the wine cellar switched on?
If the cause of failure is not to be found among the
points listed above, contact an authorised service
technician.
The wine cellar is equipped with an overheating
protection. An authorised service technician can
check whether this has been triggered or not.
INSTALLATION OF GUIDES AND SHELF
SUPPORTS
GUIDES FOR SLIDING SHELVES
Place the rear hook of the guide in front of the
desired hole in the rear row and push in direction
SHELF SUPPORT FOR STORAGE SHELF
Place the support hooks in the holes at desired
Reinforcement bar
The reinforcement bar is a shelf support and must
not be removed for safety reasons.
Model Max. no. of sliding shelves
1
2
REINFORCEMENT
BAR
Model
No. of
storage shelves
No. of
bottles
1
2
CautiOn
Note that you should store no more than one layer
of bottles on the sliding shelves.