installation & operating instructions MODEL: CK400 ERTEK INT Type: CK 825120104 e5 030224 MO-M 0716
contents product overview__________________________ 4 operating instructions & product care_____ 6 installation instructions___________________ 4 controls. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Before installing . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Cleaning. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6 Placing the ventilator. . . . . . . . . . .
product overview Thank you for choosing this quality cooker hood. It has been designed to give years of troublefree service, provided it is installed and maintained correctly. CK400 is intended for use in caravans, motorhomes and boats and designed to be placed above the food preparation area, preferably built-in to an existing top cupboard. Please note that it has to be placed at a minimum distance of 50 cm from any open flame.
installation instructions Before installing Before installing, please check the following: ✓ Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards. ✓ Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel burning equipment to prevent back drafting. ✓ When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.
operating instructions & product care controls ! WARNING Always disconnect the cooker hood from the mains supply before cleaning or changing any parts. Fan motor Light Cleaning General instructions Half speed Low light Please observe that the surfaces and controls are susceptible to scratches and abrasions. All external surfaces and controls can be cleaned using warm water with a little washing-up liquid applied with a sponge or cloth. Wipe the surfaces dry using a soft cloth.
operating instructions & product care Changing the halogen lamp To change the lamp, follow these steps: 1. Halogen lamps get very hot during use and remain hot for some time after being switched off. Please allow the halogene lamps to cool before removing. 2. Gently pull to remove the lamps from their sockets. . Replace with halogen lamps of the same specification (10W, 12V GU4).
