Operating Instructions and Installation Instructions

EN
Dometic CK150 Mounting the extractor hood
19
5.1 Control elements
6 Mounting the extractor hood
Note on installation location
The extractor hood should preferably be mounted above the cooking zone
and built into a suspended cabinet if possible. The distance between the gas
hob flame and the extractor hood must be at least 50 cm.
The fan should be mounted on the roof on a level surface. When mounted on
a sloping surface, the roof hood must be rotated so that one of the three wa-
ter drainage holes is directed toward the incline. A tilt angle up to 20° will not
affect the performance of the fan when the motor is not running.
6.1 Mounting the fan
➤ Select an appropriate installation location for the fan on the roof.
➤ Draw the location and size of the opening of 105 mm diameter (fig. 3,
page 3).
➤ Pre-drill and cut out the hole on the roof carefully with a keyhole saw or
similar tool.
➤ Place the fan on the opening and mark the six screw holes.
➤ Apply a thin ring of a permanently elastic sealing material around each
hole.
➤ Put the rubber seal (fig. 5 4, page 4) into the groove on the underside of
the fan.
No. in
fig. 2,
page 3
Description
1 Filter
2 Fan On/Off switch
3 Light On/Off switch
4 Halogen lamp