Technical data

9
6. Visual check of flame
The burners of the Cramer glass ceramic cooktop burn beneath the glass ceramic panel.
Due to the dark shade of the panel, the ignited burner is not visible until approximately 1
minute after ignition. Due to a patented feature of the burner, only part of the burner
surface is red hot, resulting in a pattern similar to a cake from which every other piece has
been eaten.
- The flame must burn steadily and with an even color.
- If the flame does not burn evenly, check to make sure that the inlet and outlet openings
are unobstructed. Any obstructions must be removed.
- If in doubt, consult a specialized gas technician.
7. Electrical supply and connection:
- Electric supply of the appliance: 12 volt DC.
- For the electrical connection, use a two-wire, 1.5 mm
2
red and black cable, which must
be connected to the terminal at the front right of the appliance. The two poles are
marked + and – on this terminal. The positive pole is red. Make sure to use the correct
polarity when connecting the cable! The electrical circuit must be protected with a 10 A
safety fuse (not included).
NEVER CONNECT THE APPLIANCE TO THE 220 VOLT MAINS
NETWORK! THIS WOULD NOT ONLY DESTROY THE ELECTRICAL AND
ELECTRONIC COMPONENTS, BUT WOULD ALSO ENDANGER THE USER.
8. Gas leaks
When inspecting for gas leaks, we recommend the use of an electronic type tested gas
detector. In case of malfunction, the valve of the gas supply network should be closed.
Then contact a gas fitter, dealer or specialized technician.