Technical data

3
Important: During initial startup and after replacing the gas cylinder, ignition may
take longer than 15 seconds due to air in the gas lines.
1.2 Operation
Important: the surfaces of the glass ceramic cooking zones become HOT during
operation, even though no open flame is visible. Therefore, DO NOT ALLOW
CHILDREN near the appliance!
The appliance has two burners. The left burner is larger, with a diameter of
200 mm and a capacity of 1.8 kW. This burner is controlled by the knob in the
back. The right burner has a diameter of 180 mm and a capacity of 1.5 kW.
This burner is controlled by the knob in the front. Behind each burner there is
a warming zone, which is heated by the exhaust gas of the burner in front of
it. This means that the surface temperature in these warming zones is lower
than over the burners. Nevertheless, the warming zones can still be used for
cooking. In other words, you can operate one burner with 2 pots; however, the
pot in the back will not receive as much heat as the one in the front. The
temperature of the glass ceramic hot plate is infinitely variable between the
"low" and "high" settings.
You can start the two burners in any order. Each control has a red LED
display, indicating that the burner is in operation (right LED = right burner,
left LED = left burner). The yellow LED display in the middle lights up when
the appliance is turned off. This display indicates that the cooking surface of
the glass ceramic panel is still hot. It is intended as a warning not to touch the
hot surface and goes out automatically approx. 20 minutes after the appliance
has been switched off.
Caution: If only one cooktop panel is switched off and the other one is still in
operation, the heat indicator does not light up, even though the cooking
surface still remains hot for some time.
1.3 Switching off the appliance
- Turn control knob clockwise to off position ("0"). The cooktop switches off.
- Close shut-off valve.
- Close valve on gas cylinder (in case of extended non-use).
Caution:
Do not disconnect the electric power supply immediately after switching off the
appliance.
The appliance must remain connected for at least 1 minute after closing the gas
valves so that it is supplied with sufficient cool air from fans requiring electricity.
After the electric power supply has been disconnected, the heat indicator is no longer
active.
2. Malfunctions, inspection and maintenance
2.1 In the event of any malfunction:
- switch off the appliance immediately
- shut off the gas supply (shut-off valve, gas cylinder valve)
- call a gas technician
- never attempt to eliminate a malfunction yourself