Technical data

2
Congratulations on your purchase of the Cramer gas glass ceramic cooktop CC05. You have
chosen a cooking appliance that offers the convenience found in most modern-day
households.
A. Operating Instructions
1. Using the appliance
1.1 First-time use
Before you use the appliance for the first time, make sure:
- that the appliance has been installed by an authorized gas specialist with CORGI
(Council for Registered Gas Installers) Registration.
- that the correct type of gas has been connected! The glass ceramic cooktop is designed
for liquid gas, i.e. butane, propane or mixtures of these. Other types of gas will not
only impair the proper functioning of the appliance, but can also cause dangerous
situations. The supply pressure of your appliance can be found on the type plate.
- that the air inlet and outlet vents on the outside of the vehicle are not blocked! The
glass ceramic cooktop uses these vents for the intake of fresh air and for the outlet of
exhaust gas.
- that the exhaust line is never installed at a slope.
- that the supply voltage is between 11.5 – 12.5 V (DC)! The electric circuit must be
protected by a 10A safety fuse. Excessive voltage can damage the appliance.
Insufficient voltage can make it difficult to ignite the appliance.
- that the glass ceramic hot plate is clean! Impurities can damage or disfigure the glass
ceramic hot plate (from baking-on or scratching).
Once all items on this checklist have been carefully examined and confirmed, you can
operate the appliance as follows:
- Open valve on gas cylinder
- Open shut-off valve
- Ignite the appliance as follows:
a) Set knob to 0 position (front knob for right burner, rear knob for left burner).
b) Press knob until the starter cylinder begins to glow.
c) Important: The starter cylinders are visible as red dots beneath the glass
ceramic hot plate. If they are not visible, then there is a defect in the
electrical system. Discontinue the ignition process and have the electrical
system checked.
d) Keep knob pressed and turn to high position.
e) Press the knob for max. 15 seconds until the ignition process is complete and
the thermo-electric safety pilot is activated.
f) Release knob. The burner must now be burning.
g) If the burner is extinguished after releasing the knob, repeat the ignition
process (a. – f.) after waiting at least 10 seconds.
h) Set the burner to the desired setting. The temperature of the glass ceramic hot
plate is infinitely variable between the "low" and "high" settings.
Important: the "0" position has a safety lock, i.e. the control knob must be pushed in
before it can be turned.