Operating Guide

EN
Servicing the awning Dometic8700
18
3.6 Reattach torsion
➤ Proceed as shown to reattach the torsion rods (fig. t, page 18).
!
3.7 Remount the awning
➤ Proceed as shown in the installation and operating manual.
3.8 Verifying the installation
➤ Verify the installation by operating the awning according to verify all parts are
functioning correctly (see Installation and Operating Manual).
WARNING!
Do not remove the nail from torsion rod until both arm caps are secured
to corresponding front channels, and awning safety lock lever is in roll
down position. Otherwise, rapid casting spin off will occur. Spring
tension will attempt to spin the hardware and/or fabric roller tube
quickly and unexpectedly.
3.
2.
1.
t
Dometic8700_SVM_APAC(en).book Seite 18 Dienstag, 23. Juni 2020 3:32 15