Specifications

ManualsBrandsDometic ManualsHeat Pump59136.521

C. Lift and place the unit over the prepared opening using

the gasket on unit as a guide. The blunt end goes

toward the rear of the RV.

DO NOT SLIDE THE UNIT. THIS MAY DAMAGE THE

NEOPRENE GASKET ATTACHED TO THE BOTTOM

AND CREATE A LEAKY INSTALLATION.

D. Place the Electronic Control Kit and the Return Air

Cover Kit inside the RV. These cartons contain

mounting hardware for the air conditioner and will be

used inside the RV.

This completes the outside work. Minor adjustments can be

done from the inside of the RV if required.

7. INSTALLATION OF AIR

CONDITIONER

A. INSTALLATION OF CEILING TEMPLATE

1) Check gasket alignment of the Air Conditioner over

roof opening and adjust if necessary. Unit may be

moved from below by slightly lifting and sliding.

2) Reach up into the return air opening of the Air

Conditioner and pull the unit electrical cord down

for later connection.

3) Remove Return Air Cover and Ceiling Template

from the 3105007 or 3105935, return air cover kit

carton.

4) Locate 1/4" unit mounting bolts in the Electronic

Control Kit package.

5) Take the ceiling template and hold up to the 14"

opening.

6) Start each mounting bolt through the ceiling tem-

plate and up into the unit base pan by hand.

7) Evenly tighten mounting bolts to a torque of 40 to

50 Inch Pounds.

This will compress the roof gasket to approxi-

mately 1/2". The bolts are self locking so over

tightening is not necessary.

8) Install wood screw in each end of ceiling template.

This insures a tight fit of return air cover to ceiling.

B. INSTALLATION OF DIVIDER PLATE

1) Measure the ceiling to roof thickness:

a. If distance is 2.00" - 3.75", remove perforated tab

from Divider Plate.

b. If distance is 3.75" - 5.50", remove no tabs.

2) Remove the backing paper from double sided tape

located on Ceiling Template.

3) Place Divider Plate up to bottom of Air Conditioner

base pan firmly. The foam tape on the divider plate

must seal to bottom of base pan.

FRONT

FIG. 8

Return A ir Grille

Return A ir

Cover

Ceiling

Template

Divider

Plate

FIG. 9

FIG. 10

FIG. 11