Specifications
7
5. DOMETIC COMFORT CONTROL
CENTER ™ & CABLE
INSTALLATION
A. LOCATION
1) If the system is to be used WITHOUT a Remote
Temperature Sensor, the proper location of the
Comfort Control Center™ is very important to
ensure that it will provide a comfortable RV tem-
perature. Observe the following rules when select-
ing a location.
a. Locate the Comfort Control Center™ 54" above
the floor.
b. Install the Comfort Control Center™ on a parti-
tion, not on an outside wall.
c. NEVER expose it to direct heat from lamps, sun
or other heat producing items.
d. Avoid locations close to doors that lead outside,
windows or adjoining outside walls.
e. Avoid locations close to supply registers and the
air from them.
2) If the system is to be used WITH a Remote
Temperature Sensor in ALL zones, the comfort
Control Center may be mounted anywhere that is
convenient in the coach. Try to avoid hard to reach
and hard to see areas.
a. Refer to the instructions provided with the Re-
mote Temperature Sensor for details of instal-
lation.
3) A 3/8" diameter hole will be needed to route the
telephone cable through the wall.
B. CONTROL CABLE INSTALLATION
A 4-conductor telephone cable must be routed from the
roof opening to the Comfort Control Center™.
1) Choose the shortest, most direct route from the
14" opening to the Comfort Control Center™
location selected. Leave 6" of cable extending
through the wall.
2) The cable that should be used is a flat, 4-conductor
telephone cable.
3) The cable must be terminated with a telephone RJ-
11 connector. Refer to the crimp tool manufacturer
for crimping instructions. Ensure that the cable is
installed into the connector correctly before crimp-
ing. (See FIG. 5).
C. COMFORT CONTROL CENTER™ IN-
STALLATION
1) Carefully remove the base plate from the Comfort
Control Center™. This may be accomplished by
inserting a screwdriver under the tab on the bottom
edge of the front cover and gently prying. (See FIG.
6).
2) Insert the telephone cable through the hole in the
base plate and mount the plate to the wall with the
two screws provided.
3) Install the control cable RJ-11 connector into the
back of the Comfort Control Center™ and gently
press onto the base plate.
6. PLACING THE AIR CONDITIONER
ON THE ROOF
A. Remove the Air Conditioner from the carton
and discard.
B. Place the Air Conditioner on the roof.
USE CARE IN LIFTING. THIS UNIT WEIGHS APPROXI-
MATELY ONE HUNDRED (100) POUNDS.
FIG. 5
FIG. 6
BE KIND -
RECYCLE ALL CARDBOARD
FIG. 7