Specifications

12
579 & 595 Installation Instructions
• If the insulation is too high, stick excess
height of insulation to the air conditioner
base pan. Do not cover up unit rating plate.
 Installing unit with 3308120 Genesis Air Filtration
System Return Air Kit. See FIG. 21. For unit with
3105007 or 3105935 Return Air Kit, see page 10.
M
i
c
r
o
-
T
h
e
r
m
F
i
l
t
e
r
S
y
s
t
e
m
Micro-Therm
Filter
System
F
I
L
T
E
R
R
E
S
E
T
FILTER
RESET
C
L
E
A
N
F
I
L
T
E
R
CLEAN
FILTER
Return Air
Cover
FIG. 21
Grill
Foam
Divider
Ceiling
Template
Slider
Filter
Handle
FIG. 18
FIG. 19
Note: The adhesive on the insulation is extremely sticky.
Be sure the part is located where desired before pressing
into place.
FIG. 20
d. With slight pressure then push the divider plate
against the double sided tape on the ceiling
template.
e. Locate the 1/8" x 7" x 18" self -adhesive insula-
tion supplied with the return air kit. Remove the
backing paper from the insulation and carefully
stick onto the ceiling template divider panel.
See FIG. 20.
• Excess width is intended to seal the di-
vider plate to the sides of the 14-1/4" x 14-
1/4" (±1/8") opening. This is to help pre-
vent cold air discharge from circulating into
the air conditioner return air opening.
1. Non Center Duct Installations
Check gasket alignment of the air conditioner over
the roof opening and adjust if necessary. Unit may
be moved from below by slightly lifting. See FIG.22.
AC Power
Supply
Pull Electrical
Cord Down
Center Unit From Below
Roof
Gasket
FIG. 22
DC Power
Supply
Receiver
Leads
Furnace
Furnace Tstat
Connection
From A/C
a. Locate the four (8" x 1/4-20) unit mounting bolts
packaged with the 3308417 control kit.
b. Reach up into the return air opening and pull
the unit electrical cord down.
c. Route AC power supply wires through the
Romex connector in the control box.
d. Connect the 6 pin plug to the control box. The
plug is polarized and will only fin in one direc-
tion. See FIG. 23
FIG. 23
Vehicle
Front
Control
Box
Base
Pan
Wires Connected To
Control Box