Specifications
10
579 & 595 Installation Instructions
2. Place the air conditioner on the roof.
G. Installing Air Conditioner
Installing unit with 3105007 or 3105935 Return Air
Cover. See FIG. 13. For unit with Genesis Air Fil-
tration System see page 12.
This unit weighs approximately 100 pounds.
To prevent back injury, use a mechanical hoist
to place air Conditioner on roof.
CAUTION
!
Do not slide the unit. This may damage the
roof gasket attached to the bottom and create
a leaky installation.
CAUTION
FIG. 13
Divider Plate
Ceiling Template
Return Air
Cover
Return Air
Grill
g. Freeze Control Installation (Two Types)
Note: Type using a snap on spring clip.
• Fits on all 579, 590, 591 and 595 Series
Brisk Air units by placing the cold control
switch up through the base pan and on the
second refrigerant tube from the bottom in
the center of the evaporator coil. Make sure
the spring clip is fastened securely to the
tubing and the cold control surface is mak-
ing contact with aluminum fins on evapora-
tor coil. See FIGS. 16 & 16A.
b. Remove return air cover and ceiling template
from the 3105007 or 3105935 kit carton.
c. Locate the four (8" x 1/4-20) unit mounting bolts
packaged with the 3308417 control kit.
d. Reach up into the return air opening and pull
the unit electrical cord down. See Section "H.
Wiring the system".
e. Route AC power supply wires through the
Romex connector in the control box.
f. Connect the 6 pin plug to the control box. The
plug is polarized and will only fin in one direc-
tion. See FIG. 15
Lift And Place
Do Not Slide
FIG. 12
Front
AC Power
Supply
Pull Electrical
Cord Down
Center Unit From Below
Roof
Gasket
FIG. 14
DC Power
Supply
Receiver
Leads
Furnace
Furnace
Tstat Con-
nection
From A/C
3. Lift and place the unit over the prepared opening
using the gasket on unit as a guide. The roof
gasket on the bottom of the base pan goes
toward the front of the RV. Sliding the unit on the
roof will damage the roof gasket. See FIG. 12.
1. Installation Of Ceiling Template
a. Check gasket alignment of the air conditioner
over the roof opening and adjust if necessary.
Unit may be moved from below by slightly lift-
ing. See FIG. 14.
Control Box
FIG. 15
White Plug
On Left
(Curb) Side
Blunt Point
Screws
Connect 6
Pin Plug