Product Manual

EN
Using the refrigerator RPD190, RPD218
26
I
7.5 Replacing the interior light
If the interior light in the refrigerator is faulty, you can change the PCB/LED board. To
order a new PCB/LED board, please contact the service partner in the respective
country (see addresses on the back of the manual).
To change the PCB/LED board, proceed as follows:
➤ Disconnect the power supply to the device.
➤ Remove the lamp cover by pressing the side clip (1).
➤ Remove the 2 screws.
➤ Remove the defective PCB/LED board.
➤ Mount the new PCB/LED board.
➤ Fasten it with the 2 screws.
➤ Attach the lamp cover (2).
➤ Reconnect the power supply.
NOTE
A stop wire (1) is fitted to the rear of the lower shelf. The purpose is to
prevent items from resting against the rear interior liner which has a low
ambient control heater fitted behind the liner in this region.
The stop wire must remain fitted to the rear of the lower shelf at all times.
21
e
RPD190-218--IO-AU.book Seite 26 Montag, 24. Oktober 2016 5:08 17