User manual

EN
General safety instructions PerfectCharge
10
2.2 Safety when installing the product
D
DANGER!
• Never mount the product in areas where there is a risk of gas or dust
explosion.
!
CAUTION!
• Ensure a secure stand!
The product must be set up and fastened in such a way that it cannot
tip over or fall down.
A
NOTICE!
• Do not expose the product to any heat source (such as direct sunlight
or heating). Avoid additional heating of the product.
• Set up the product in a dry location where it is protected against
splashing water.
2.3 Safety when connecting the product electronically
D
DANGER! Danger of fatal electric shock!
• For installation on boats:
If electrical devices are incorrectly installed on boats, this can lead to
corrosion damage on the boat. Have the product installed by a quali-
fied (boat) electrician.
• If you are working on electrical systems, ensure that there is somebody
close at hand who can help you in emergencies.
!
WARNING!
• Make sure that the lead has a sufficient cross-section.
• Lay the cables so that they cannot be damaged by the doors or the
bonnet.
Crushed cables can lead to serious injury.
!
CAUTION!
• Lay the cables so that they cannot be tripped over or damaged.
A
NOTICE!
• Use ductwork or cable ducts if it is necessary to lay cables through
metal panels or other panels with sharp edges.
•Do not lay the AC cable and DC cable in the same conduit (empty
pipe).
DCC1224-2424--IO-16s.book Seite 10 Donnerstag, 8. März 2018 3:06 15