User manual

Using the converter PerfectCharge/PerfectPower

8Using the converter

You can switch on the device as follows, depending on the connection:

• Using the main switch on the device (fig. 1 6, page 3)

• Using the ignition (fig. 5 A, page 4)

Terminal 15: Connected positive terminal

• Using an external switch (fig. 5 B, page 4)

Switching on the converter

➤ Set the main switch (fig. 1 6, page 3) on the back of the converter to “1” …

… or start the ignition …

… or push the external switch.

✓ The LEDs (fig. 1 3 to 5, page 3) indicate the operating status:

LED Colour Explanation

Power On Green The device is switched on and there is voltage at

the output terminals on the converter. The

converter is ready for use.

Battery Low Yellow The input battery is no longer sufficiently

charged.

➤ Recharge the battery or use a charged

battery.

Overload Red

If a consumer is connected:

The converter is shorted or overloaded.

➤ Eliminate the short circuit or reduce the

output load.

If connected as a charger:

The converter is in the full current charging

phase.

NOTE

The internal fan is operated according to the temperature. It only runs

when the temperature is too high. During this time the converter is

switched off to prevent overheating.

DC08-40-DCD08-40--IO-16s.book Seite 16 Donnerstag, 28. Juli 2016 2:37 14