User manual

PocketPower SI102 Technical description
EN
7
5 Technical description
The device has a compact design for portable use. The heat generated during operation is
dissipated by a fan inside the device.
5.1 Description of the device
I
6 Connecting the inverter
A
I
➤ Fasten the inverter as follows (fig. 2, page 3):
– Screw the rail to the floor.
– Push the inverter onto the rail.
➤ Insert the plug into a 12 V cigarette lighter socket or into a 12 V vehicle socket.
The middle pin (fig. 1 3, page 3) of the plug must be connected to the positive (+) wire and
the two side brackets (fig. 1 2, page 3) of the plug must be connected to the negative (–)
wire.
NOTE
The version for continental Europe is pictured.
No. in
fig. 1, page 3
Description
1 Status LED blue
2 Negative contact
3 Positive contact
4 230 Vw output
5 USB charger connection
NOTICE!
• The cable between the battery and the inverter may not exceed a maximum length
of 2 m.
• Make sure the plug (fig. 1 4, page 3) is firmly connected to the vehicle socket. If
the connection is loose, the plug may heat up and cause the inverter to malfunction.
• Do not operate any connected power consuming device while driving the vehicle.
Only operate device when vehicle is stationary.
NOTE
If you connect the device to the cigarette lighter, remember that the ignition must be
turned on to supply it with power.
SI102-O-16s.book Seite 7 Dienstag, 23. August 2016 5:29 17