User manual

EN
PerfectPower Connecting the inverter
11
6 Connecting the inverter
A
6.1 Fastening the inverter
You can fasten the inverter using the four holders supplied.
When selecting the installation location, observe the following instructions:
• The inverter can be mounted horizontally or vertically.
• The inverter must be installed in a place that is protected from moisture.
• The inverter may not be installed in the presence of flammable materials.
• The inverter may not be installed in a dusty environment.
• The place of installation must be well-ventilated. A ventilation system must be
present for installations in small, enclosed spaces. The clearance around the
inverter must be at least 25 cm (fig. 4, page 5).
• The air intake on the underside or the air outlet on the back of the inverter must
remain clear.
• For ambient temperatures higher than 40 °C (such as in engine or heating com-
partments, or direct sunlight), the heat from the inverter under load can lead to
the automatic shut-off of the inverter.
• The installation surface must be level and sufficiently sturdy.
A
Fasten the inverter as follows (fig. 5, page 5):
➤ Clip two holders on the lower left bar and two on the right.
You can move the holders as required.
➤ Fasten the inverter by screwing one screw through each hole in the holders.
NOTICE!
The cable between the battery and the inverter may not exceed a
maximum length of 2 m.
NOTICE!
Before drilling any holes, ensure that no electrical cables or other parts
of the vehicle can be damaged by drilling, sawing and filing.
PP150-PP400-PP600--IO-16s.book Seite 11 Mittwoch, 18. Januar 2017 1:13 13