User manual

SinePower Connecting the inverter

8.3 Mounting the inverter

➤ Hold the inverter against the installation location and mark the fastening points

(fig. 3 A, page 4).

➤ Attach the inverter using your chosen fastening method (fig. 3 B, page 4).

9 Connecting the inverter

9.1 General instructions

• When installed in vehicles or boats, the inverter must be connected to the chassis

or earth.

• When setting up a socket distribution circuit (mains setup), comply with the appli-

cable regulations.

• Only use copper cables.

• Keep the cables as short as possible (< 1 m).

• Keep to the specified cable cross section and fit a cable fuse (fig. 4 3, page 4)

as close to the battery as possible on the positive cable (see the table).

WARNING!

• The inverter may only be connected by a qualified workshop. The

following information is intended for technicians who are familiar

with the guidelines and safety precautions to be applied.

• Never use the inverter on vehicles where the positive terminal of the

battery is connected to the chassis.

• If you do not fit a fuse to the positive cable, the cables can over-

load, which might result in a fire.

Device

Required cable

cross section

Cable fuse

MSI2312T 70 mm² 350 A

MSI2324T 50 mm² 175 A

MSI3512T 95 mm² 400 A

MSI3524T 70 mm² 200 A

MSI2300-3500--IO-16s.book Seite 17 Mittwoch, 3. August 2016 5:46 17