User manual

SinePower Troubleshooting

12 Troubleshooting

The LED (fig. 5 2, page 4) lights up red to indicate the fault:

WARNING!

Do not open the device. You risk sustaining an electric shock by doing

this.

NOTE

If you have detailed questions on the specifications of the inverter

please contact the manufacturer (addresses on the back of the instruc-

tion manual).

LED display Cause Remedy

Quick flash Input voltage is too high Check the input voltage and reduce it.

Slow flash Input voltage too low The battery needs recharging.

Check the cables and connections.

Occasional flash Overheating Switch off the inverter and the consumer.

Wait 5 to 10 minutes and switch the inverter

on again without any electric consumers.

Reduce the load and make sure the inverter

has better ventilation. Then switch the con-

sumer back on.

Constantly lit Short circuit or reversed

polarity

Excessive load

Switch off the inverter and remove the

consumer.

Then switch the inverter back on without the

consumer. If no excessive load is now shown,

then there is a short circuit in the consumer or

the total load was higher than the power

specified on the data sheet. The fuse in the

device must be pressed in again by hand after

it has been triggered by excess current.

Check the cables and connections.

MSI2300-3500--IO-16s.book Seite 27 Mittwoch, 3. August 2016 5:46 17