User manual

EN
Connecting the inverter SinePower
22
9.2 Connecting the inverter to the battery
I
➤ Put the main switch (fig. 6 1, page 4 to fig. 8 1, page 5) on ‘OFF’.
➤ Loosen the screw (fig. 9 1, page 6) from the red positive terminal (fig. 9 2,
page 6).
➤ Push the cable lug (fig. 9 2, page 6) of the positive cable into the red positive
terminal and fasten it with the screw.
➤ Connect the negative cable corresponding to the black negative terminal
(fig. 9 4, page 6).
➤ Lay the positive cable from the inverter to the positive terminal of the vehicle
battery and connect it.
➤ Lay the negative cable from the inverter to the negative terminal of the vehicle
battery and connect it.
➤ Connect the earth terminal with the vehicle body earth.
9.3 Connect the 230 V supply cable
(only MSI1800T, MSI1800TOE)
➤ Plug in the 230 Vw connection cable with Schuko plug into the 230 Vw input
bush (fig. 7 6, page 5 and fig. 8 5, page 5).
➤ Connect the Schuko plug to the 230 V AC mains.
9.4 Connect the 230 V output cable
(only MSI1800T, MSI1800TOE)
!
➤ Plug the 230 Vw connection cable with Schuko coupling into the
230 Vw output bush (fig. 7 5, page 5 and fig. 8 5, page 5).
NOTE
Tighten the screws or nuts with a torque of 12 – 13 Nm. Loose connec-
tions may cause overheating.
WARNING!
Before connecting the 230 V output cable, make sure the inverter is
switched off at the main switch.
MSI900-1800--IO-16s.book Seite 22 Dienstag, 20. Juni 2017 9:59 09