User manual

EN
Mounting the inverter SinePower
20
8.2 Installation instructions
When selecting the installation location, note the following:
• The inverter can be mounted horizontally or vertically.
• The inverter must be installed in a place that is protected from moisture.
• The inverter may not be installed in the presence of flammable materials.
• The inverter may not be installed in a dusty environment.
• The place of installation must be well ventilated. A ventilation system must be
available for installations in small, enclosed spaces. The minimum clearance
around the inverter must be at least 25 cm (fig. 3, page 3).
• The air intake on the underside or the air outlet on the back of the inverter must
remain clear.
• For ambient temperatures higher than 40 °C (such as in engine or heating
compartments, or direct sunlight), the heat from the inverter under load can lead
to automatic shutdown.
• The device must be installed on a level and sufficiently sturdy surface.
A
8.3 Mounting the inverter
➤ Hold the inverter against the installation location you have chosen and mark the
fastening points (fig. 4 A, page 4).
➤ Attach the inverter using your chosen fastening method (fig. 4 B, page 4).
NOTICE!
Before drilling any holes, make sure that no electrical cables or other
parts of the vehicle can be damaged by drilling, sawing and filing.
MSI900-1800--IO-16s.book Seite 20 Dienstag, 20. Juni 2017 9:59 09