User manual

EN
SinePower General safety instructions
13
• Electrical devices are not children’s toys
Always keep and use the device out of the reach of children.
2.2 Safety when installing the device
!
WARNING!
• Installing the device may only be performed by qualified personnel
who are familiar with the guidelines and safety precautions to be
applied.
• If electrical devices are incorrectly installed on boats, corrosion
damage might occur. The device should be installed by a specialist
(marine) electrician.
A
NOTICE!
• Ensure that the device is standing firmly.
The device must be set up and fastened in such a way that it cannot tip
over or fall down.
• Do not expose the device to a heat source (such as direct sunlight or
heating). Avoid additional heating of the device in this way.
• If cables have to be fed through metal walls or other walls with sharp
edges, use ducts or tubes to prevent damage.
• Do not lay cables which are loose or bent next to electrically conduc-
tive material (metal).
• Do not pull on the cables.
• Do not lay the 230 V mains cable and the 12/24 V DC cable in the
same duct.
• Fasten the cables securely.
• Lay the cables so that they cannot be tripped over or damaged.
2.3 Operating the device safely
!
WARNING!
• Only operate the device if you are certain that the housing and the
cables are undamaged.
• Even after the fuse triggers, parts of the inverter remain live.
• Always disconnect the power supply when working on the device.
MSI900-1800--IO-16s.book Seite 13 Dienstag, 20. Juni 2017 9:59 09