User manual

again. If you have chosen a delayed start,
the machine will begin the countdown.
If an incorrect option is selected, the red pi-
lot light of the button 5 blinks for 3 times.
Altering an option or a running
programme
It is possible to change some options be-
fore the programme carries them out.
Before you make any change, you must
PAUSE the appliance by pressing the but-
ton 5.
Changing a running programme is possible
only by resetting it. Turn the programme se-
lector dial to OFF position and then to the
new programme position. Start the new
programme by pressing the button 5 again.
The washing water in the tub will be not
emptied out.
Interrupting a programme
Press the button 5 to interrupt a pro-
gramme which is running, the correspond-
ing green pilot light starts blinking.
Press the button again to restart the pro-
gramme.
Cancelling a programme
Turn the selector dial to << OFF >> posi-
tion to cancel a programme which is run-
ning.
Now you can select a new programme.
Opening the door
After the programme has started (or during
the delay time) the door is locked, if you
need to open it, set first the machine to
PAUSE by pressing the button 5. After a
few minutes the light 7.2 goes out and it is
possible to open the door.
If this light remains lit and the door is
locked, this means that the machine is al-
ready heating or that the water level is too
high. In any case, do not try to force the
door open!
If you cannot open the door but you need
to open it you have to switch the machine
off by turning the selector dial to OFF . After
a few minutes the door can be opened
(pay attention to the water level and
temperature!).
After closing the door, it is necessary to se-
lect the programme and options again and
to press button 5.
At the end of the programme
The machine stops automatically. The pilot
light of button 5, the pilot lights 7.1 and 7.2
go off. The light 7.3 illuminates.
If a programme or an option that ends with
water left in the tub has been selected, the
pilot light 7.2 remains on and the door is
locked to indicate that the water must be
emptied out before opening the door.
Follow the below instructions to empty out
the water:
1. Turn the programme selector dial to
OFF .
2. Select the draining or spinning pro-
gramme.
3. Reduce the spin speed if needed, by
pressing the relevant button.
4. Press button 5.
At the end of the programme, the pilot light
7.2 goes off to indicate that the door can
be now opened. Turn the programme se-
lector dial to OFF to switch the machine off.
Remove the laundry from the drum and
carefully check that the drum is empty. If
you do not intend to carry out another
wash, close the water tap. Leave the door
open to prevent the formation of mildew
and unpleasant smells.
Helpful hints and tips
Sorting out the laundry
Follow the wash code symbols on each
garment label and the manufacturer’s
washing instructions. Sort the laundry as
follows: whites, coloureds, synthetics, deli-
cates, woollens.
Before loading the laundry
Never wash whites and coloureds together.
Whites may lose their «whiteness» in the
wash.
New coloured items may run in the first
wash; they should therefore be washed
separately the first time.
9