User`s guide

Dome Sx Display User’s Guide, 020-0931-00 Rev. F | 7
Display Components
Review the following illustrations to identify controls and ports on
the front and back panels of the Dome Sx displays.
The sensor on the front of the Dome S3, Dome S3c, and Dome S6c
displays allows you to run an auto-conformance test without using
the photometer.
On the S3 series the sensor is located on the side bezel as shown in
the preceding illustration.
On the Dome S6c display, the sensor is underneath the front bezel at
the bottom center.
The MQSA (Mammography Quality Standards Act) button (lower
right, beneath display ID) on the Dome S10 display facilitates any
daily, weekly, or annual tests that you have preset via calibration and
monitoring software.
Front sensor on Dome S3/Dome S3c MQSA button on Dome S10