User`s guide

Dome Sx Display User’s Guide, 020-0931-00 Rev. F | 33
Regulatory Compliance
Canada, European Union, United States
This display has been tested and found to comply with IEC 60601-1:2005 and
EN 60601-1:2006, and IEC/EN 60601-1-2 standards, and is certified to meet
medical standard CAN/CSA C22.2 No. 60601-1-A and UL 60601-1 ANSI/AAMI
ES60601-1:2005 (R2012).
The medical display, in addition to
meeting medical requirements,
has been tested and found to
comply with the limits for Federal
Communications Commission
(FCC) Class A computing devices
in a typically configured system since many medical offices are located in
residential areas. It is the system integrator’s responsibility to test and ensure
that the entire system complies with applicable electromagnetic
compatibility (EMC) laws.
WARNING! Users of Dome Sx Displays
The Dome S3, Dome S3c, Dome S6c, and Dome S10 displays are Class A
products. In a domestic environment, either of these products may cause
radio interference, in which case the user may be required to take adequate
measures.
Radio transmitting equipment, cellular phones, etc. shall not be used in
close proximity of the devices, since this could influence the performance
of the device.
Particular precaution must be considered during use of strong emission
sources, such as High Frequency surgical equipment and similar, so that,
for example, the HF-cables are not routed on or near the devices. If in
doubt, contact a qualified technician or your local representative.
This equipment/system is intended for use by healthcare professionals
only. This equipment/system may cause radio interference or may disrupt
the operation of nearby equipment. It may be necessary to take mitigation
measures, such as reorienting or relocating the Dome Sx display or
shielding the location.
Dome S3, Dome S3c, Dome S6c, and
Dome S10