User`s guide

10 | Dome Sx Display User’s Guide, 020-0931-00 Rev. F
Installing the Display
First, turn your computer off. Next, leave the power cord plugged into
the grounded outlet. Then install the Dome Sx display using only the
power adapter and video cable that shipped with the unit.
Connecting the Video Cable and Power Cord
IMPORTANT! Note the following:
• For the Dome S3 or Dome S3c display only: Install either the DVI or
the DisplayPort cable, not both.
• If the power adapter that came with your display unit has an on/off
switch, after installation, turn on the adapter before you turn on the
computer.
To connect the cables
1 Plug the power cord of the adapter into the power input port on
the connector plate, then plug the other end into the input socket
of the adapter. Plug the power supply cord into a grounded AC
outlet.
2 Plug one end of the video cable into the primary video port on
the connector plate and secure the connection. Plug the other end
of the cable into the video port on the installed graphics card and
secure the connection. Repeat this step for a secondary video cable
installation.
3 Turn on the adapter power before you turn on the computer.
WARNING
No modification of this equipment is allowed.
In locations where 240V outlets are used, connect the
Dome Sx display only to a center-tapped, 240V, single-
phase supply (for Canada and the United States only).